Was this support article useful? YES Thank you for your feedback. Feedback Please tell us how we can make this article useful. Software does not include any Open Source Software as defined below. As part of this license, you may A operate the Software in the manner described in the user documentation for the Software; B where the Software is provided for download onto a personal computer or mobile device, make as many copies of the Software as you reasonably need for your own use this does not include firmware ; and C permanently transfer all of your rights to use the Product including but not limited to the Software to another person, so long as that person also agrees to be bound by this Agreement, and following such transfer you stop using the Product and the Software. The Software is licensed, not sold, to you.

Author:Mokasa Dular
Language:English (Spanish)
Published (Last):11 May 2017
PDF File Size:11.53 Mb
ePub File Size:16.5 Mb
Price:Free* [*Free Regsitration Required]

All rights reserved. Page 5: Chapter 1: Product Overview Product Overview is flashing, the Router is actively sending or receiving data over the network. The Router lets you access the Internet via a Page 6 Router down until the screws fit snugly into the true to scale.

NOTE: Linksys is not responsible for damages incurred by insecure wall-mounting hardware. Cut along the dotted line, and place on the wall to drill precise spacing. Page 7: Chapter 2: Wireless Security Checklist 3.

The MAC address is a unique series of numbers and letters assigned to every networking device. The default Max Idle Time is 15 minutes. Page 10 Advanced Configuration Chapter 3 inactivity, Connect on Demand enables the Router to Telstra Cable automatically re-establish your connection as soon as you Telstra Cable is a service that applies to connections in attempt to access the Internet again.

To use this option, Australia only. Page 11 Advanced Configuration Chapter 3 host and domain name. After the time is up, the user will be automatically assigned a new dynamic IP address. The default is 0 minutes, which means one day. Click Save Settings to apply your changes, or click Cancel Changes to cancel your changes. For added security, you should change Mask, Gateway, and Interface are displayed. Click the default SSID linksys to a unique name. Refresh to update the information.

Click Close to exit this screen. Then refer back to your client device or its There are three methods available. Use the method that documentation for further instructions. Select Shared Key to This screen shows computers and other devices on only use Shared Key authentication.

The default value is 1. Fragmentation Threshold Filter Multicast This value specifies the Multicasting allows multiple maximum size for a packet before data is fragmented transmissions to specific recipients at the same time. Check with the Internet To forward a port, enter the information on each line for application documentation for more information.


Cisco Linksys WRT120N User Manual

Page 5: Chapter 1: Product Overview Product Overview is flashing, the Router is sending or receiving data over the network. The Router lets you access the Internet via The distance between the slots is mm 6 inches. Two screws are needed to mount the Router. Suggested Mounting Hardware mm Enable encryption Wireless Security Checklist Encryption protects data transmitted over a wireless network. If you supply a host and domain name for the Router.


Linksys WRT160N - Wireless-N Broadband Router Wireless User Manual

Here are some steps to help you configure it. Use an ethernet cable, and plug your computer into the router. Then turn on the router and connect to it using a web browser such as Internet Explorer or Firefox. This is done by typing the IP address of the router.


WRT160N User Guides


Related Articles